Ipnat inside source list 1 interface GigabitEthernet0/0 overload ! Last configuration change at 15:03:45 UTC Sun byĮnable secret 5 $1$Sx2k$wiHT8Af585IB/HsSZkwC61
"established" statement at the start and end of the 101 list, no Listed (101 and 102) but not enabled on the gig0/0 interface.I have tried the I add the ip access-group XXX in / out to the gig0/0 interface, I lose all wwwįunctionality at that point.Here is my current (working) config with the ACLs To Cisco ACLs and so I expect I'm doing something stupid but not sure what.When Network needs standard "internet" access. (SSH) and 873 (rsync) to run an rsync server on my network and the rest of the I have a Cisco 1921 and need to open ports 22 Or a local hostname configured, you can use ping with names, like this: Return was 36ms, the average time (of all 5 pings) for a reply to return isģ6ms, and the maximum time for a ping reply to return was 40ms. I was told that the round-trip minimum time for a ping reply to That isīecause it says that I sent 5 pings and received 5 ping replies back (that is Notice on the last line that the “Success rate is 100 percent”. This is a safeĪssumption considering 2 seconds is 2000ms and I am getting pings back in aboutģ6ms. That means that if a response was not received within 2 seconds, ping wouldĭecide that the packet was not going to return at all. I was told that the timeout was 2 seconds. Lifetime exceeded Besides the five exclamation points, I was also told that I “M” = could not fragment - “?” = unknown packet type - “&” = packet “U” = destination unreachable - “Q” = source quench (destination too busy). Note that if the ping was not successful, you would have received one of theįollowing (instead of an exclamation point): - “.” = network server timed out.
0 kommentar(er)
